Short answer: yes. Stanley 40oz lids, Yeti lids and Hydro Flask lids all fit the same organizer, and so do most other standard round tumbler lids. What decides fit is the drinking opening in the lid, not which brand made it.
Here is what actually determines whether a lid fits, which shape suits which cabinet, and the one mistake that makes an under-cabinet mount fail.
Fit is about the opening, not the brand
Almost every tumbler lid made in the last few years has a drinking opening — the slot you sip from, or the hole the straw goes through. A lid organizer works by passing a rod through that opening, so the lids hang or stack on the rod instead of sliding around a drawer.
So the question is never whether you need a Stanley shelf or a Yeti shelf. It is whether the lid has an opening. If it does, it fits.
Brands whose lids have a drinking opening include Stanley, Yeti, Hydro Flask, Owala, Simple Modern and most supermarket tumblers.
The exceptions are lids with no opening at all — a few sealed travel caps and some screw-on bottle tops. There is nothing for a rod to pass through, and no rod organizer will hold them.
Two shapes, and which cabinet each one suits
There are two ways to solve the same problem. The right one depends on where the spare space is in your kitchen rather than on which lids you own.
A vertical rod, standing on the shelf
Lids slide down over a steel rod and stand upright in one column. It holds up to ten lids and takes 3.5 inches of shelf or counter — about the footprint of a coffee mug. There is nothing to install: it is freestanding, no tools and no drilling, and the weight of the lids is what keeps it steady.
Choose this if you have shelf depth to spare but not much height, or if you rent and would rather not fix anything to the cabinet. This is the Tumbler Lid Organizer — Vertical.
A rod under the cabinet
The same idea turned sideways and mounted to the underside of a cabinet or a shelf, so the lids hang in the dead air above the counter and use no shelf space at all. It holds with strong 3M self-adhesive — no tools, no drilling, nothing screwed into the wood.
Choose this if your shelves are already full. This is the Tumbler Lid Organizer — Under-Cabinet.
The one mistake that makes an adhesive mount fail
Clean the surface first, and give the adhesive a full 24 hours before you load any lids onto it. Mounting it and hanging ten lids on it the same afternoon is the single reliable way to make it let go.
Why lids waste so much space in the first place
Lids are an awkward shape. They are wide and shallow, so ten of them lying flat cover most of a shelf while using almost none of the height above. Stood on edge in a drawer they slide and fan out every time the drawer moves.
Standing them upright on a rod turns that wide flat area into a narrow column. Ten lids in 3.5 inches is the same shelf space as one mug, and you can see every lid at once instead of digging.
When this is the wrong call
If you own two or three lids, a rod is more than you need — a small container at the front of the shelf does the job. The case for an organizer starts when the lids outnumber what you can see at a glance, which is usually around six.
And if your lids seal completely with no opening, none of this applies. Check one before you buy.
Questions people ask
Do Stanley 40oz lids fit? Yes. The 40oz lid has a straw opening, which is what the rod passes through.
Will Yeti and Stanley lids fit on the same one? Yes — you can mix brands freely on one rod. Nothing is sized to a particular lid.
How many lids does it hold? Up to ten on the vertical version.
Does it need drilling? No. The vertical one stands on the shelf. The under-cabinet one uses 3M adhesive.
Are they patented? Both designs are patent pending.
Can I wash the lids and put them straight on? Let them dry first. Storing lids wet is what makes a cupboard smell — more on that in how to store tumbler lids.
